GFE support does not appear to be included in the Unidata AWIPS II release,
i.e. on the EDEX side, none of the GFE required ingest processing is configured
or even included in the repo RPMS. Same with Hydro and MPE persepctives. You
have to install and run the NWS partner site AWIPS II to get GFE but you cannot
mix and match (i.e. run a Unidata CAVE from a NWS-spec edex and vice-versa.)
--
Erik Magnuson
________________________________
From: awips2-users-bounces@xxxxxxxxxxxxxxxx
[awips2-users-bounces@xxxxxxxxxxxxxxxx] On Behalf Of Michael Foland
[mfoland@xxxxxxxxxxxxxxx]
Sent: Tuesday, October 07, 2014 2:14 PM
To: awips2-users@xxxxxxxxxxxxxxxx
Subject: [awips2-users] GFE Problems
Getting a lot of Python errors when you go to launch GFE. Also it gives an
error bout the maps not loading. Any reason why GFE isn’t working?
________________________________
The information contained in this email message is intended only for the use of
the individual(s) to whom it is addressed and may contain information that is
privileged and sensitive. If you are not the intended recipient, or otherwise
have received this communication in error, please notify the sender immediately
by email at the above referenced address and note that any further
dissemination, distribution or copying of this communication is strictly
prohibited.
The U.S. Export Control Laws regulate the export and re-export of technology
originating in the United States. This includes the electronic transmission of
information and software to foreign countries and to certain foreign nationals.
Recipient agrees to abide by these laws and their regulations -- including the
U.S. Department of Commerce Export Administration Regulations and the U.S.
Department of State International Traffic in Arms Regulations -- and not to
transfer, by electronic transmission or otherwise, any content derived from
this email to either a foreign national or a foreign destination in violation
of such laws.
