[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: 20060317: gdgsfc question

Chiz,

The problem was the tab delimited entry.  I thought I had fixed that
before sending the email to you, but just to make sure, I went through
each space again, deleted it, and added spaces.  This fixed the problem.

Thanks!
Jon 

-----Original Message-----
From: Steve Chiswell [mailto:address@hidden] 
Sent: Friday, March 17, 2006 11:32 AM
To: Case.Jon
Cc: address@hidden; GEMPAK support
Subject: 20060317: gdgsfc question

Jon,

Double check your ATE station entry to make sure you haven't used tabs
in the columns. A look at the SLAT;SLON;SELV might give a tip as to
where the column are off, or if the data is coming from another station
in the table with that unexpected lat/lon.

Steve Chiswell
Unidata User Support

On Fri, 2006-03-17 at 09:11, Case.Jon wrote:
> Dear Gembud,
>  
> I'm tring to extract NWP point forecasts into a surface file in the 
> following manner:
>  
> (1) Created a sub-set list of the sfstns.tbl file, adding a new 
> station to the list (which I called "ATE" for now).
> (2) Created new surface file with sfcfil.
> (3) Run gdgsfc to extract the surface parameters to the stations in 
> the surface file created in (2).
> (4) Examine extracted data using sflist. 
>  
> The problem I've encountered is with the new station "ATE".  Even 
> though I defined the lat/lon and rest of its station data correctly in

> the sub-setted .tbl file, the data are not getting corrected extracted

> to the station.  In fact, sflist shows the slat and slon as completely

> incorrect, not at all reflecting the values I put into the station 
> table file used in sfcfil.
>  
> So, what can I do to get the new station data recognized within the 
> surface file?
> Thanks in advance,
> Jon
> 
> -----------------------------------------------------------------
> Jonathan L. Case, Meteorologist
> ENSCO Inc. / Applied Meteorology Unit
> 1980 N. Atlantic Ave., Suite 230
> Cocoa Beach, FL 32931
> Voice: (321) 853-8264
> Fax:    (321) 853-8415
> ----------------------------------------------------------------
> 
>  
> The information contained in this email message is intended only for 
> the use of the individuals to whom it is addressed and may contain 
> information that is privileged and sensitive. If the reader of this 
> message is not the intended recipient, you are hereby notified that 
> any dissemination, distribution or copying of this communication is 
> strictly prohibited. If you have received this communication in error,

> please notify the sender immediately by email at the above referenced 
> address. Thank you.
> 

The information contained in this email message is intended only for the use of 
the individuals to whom it is addressed and may contain information that is 
privileged and sensitive. If the reader of this message is not the intended 
recipient, you are hereby notified that any dissemination, distribution or 
copying of this communication is strictly prohibited. If you have received this 
communication in error, please notify the sender immediately by email at the 
above referenced address. Thank you.