NetCDF data may include variable values that are not written, either on purpose or unintentionally. To detect attempts to later read unwritten data, the netCDF library initializes data with either

• the value of a variable's _FillValue attribute, if it exists, or else

• a type-specific default fill value, defined as part of the netCDF interface, or
• nothing, leaving the value undetermined, if the writer sets "no fill" mode.

• Use the default netCDF fill values for each type or specify a fill value with the _FillValue attribute.
• For floating-point data, consider using an IEEE NaN (Not a Number) value, because any computation using a NaN results in a NaN. Detection of NaNs requires special care, for example use of isnan() function.
• Alternatively or in addition, set the valid_range attribute for each variable that uses missing values, and make sure all valid data is within that range, and all missing or invalid data is outside of that range. Again, the client software must recognize and make use of this information. Example:

  variables:
    float rel_humidity( z, y, x);
      rel_humidity:units = "percent";
      rel_humidity:valid_range = 0.0f, 1.0f;
  

• The _FillValue attribute, if used, should have the same data type as the variable it describes. If the variable is packed, _FillValue should use the packed type.
• Turning on "no fill" mode can make writes faster, but this may be an unwise optimization unless you know you will write all data values: it prevents later detection of unwritten data.

2011 Unidata NetCDF Workshop > Best Practices