Are you running Parallels Access by any chance? I've observed this same
behavior with IDV 5.0 on my mac (also OSX 10.9.3). After much trial and
error I narrowed the problem down to the fact I was running the parallels
access utility, installed by default when I installed Parallels. Quitting
out of the utility lets me launch the IDV 5.0 normally.
Hope this helps!
-Ward
On Fri, Jun 13, 2014 at 4:42 PM, William Capehart <wjcapehart@xxxxxxxxx>
wrote:
> Hello All:
>
> I installed IDV 5.0 on my Mac (OS X 10.9.3) and it seems to be hanging on
> startup once the Dashbard and view window are loaded leaving me with the
> spinning wait cursor with no relief until I force a quit. The nightly
> release is also showing the same problem. Has anyone else ran into this?
>
> ================================================================
> Bill Capehart <William.Capehart@xxxxxxxxx> Associate Professor
> Atmospheric & Environmental Sciences AES PhD Coordinator
> 213 Mineral Industries Building Skype/EVO: wcapehart
> South Dakota School of Mines and Technology Ph: +1-605-394-1994
> 501 East Saint Joseph Street Fax: +1-605-394-6061
> Rapid City, SD 57701-3995 Mobile: +1-605-484-5692
> =================== http://capehart.sdsmt.edu ==================
>
>
>
>
>
> _______________________________________________
> idvusers mailing list
> idvusers@xxxxxxxxxxxxxxxx
> For list information, to unsubscribe, visit:
> http://www.unidata.ucar.edu/mailing_lists/
>
>
